SKU: 84411136256
mature aglaonema

mature aglaonema Aglaonema 'Spring Red'

Sale price$18.60 Regular price$20.67
Save 10%

Shipping Estimate
USA
  • USA
  • CAN

Ships within 48 hours · Estimated delivery Jul 13 - Jul 18

Promo Codes Available:

For Your Every Summer RSVP, with Code: SUMMER15

Description

mature aglaonema Aglaonema 'Spring Red'Aglaonema 'Spring Red' Aglaonema 'Spring Red' is a compact Chinese evergreen grown for warm red pink colour across a dense, upright clump. New leaves rise from short stems and build a rounded crown with visible colour across the upper leaves. The leaves are smooth, oval to lance shaped and slightly glossy, with red to salmon pink colouring near the midrib and green tissue around the blade edge. As new growth expands, the colour sits close to the

Aglaonema 'Spring Red'

Aglaonema 'Spring Red' is a compact Chinese evergreen grown for warm red-pink colour across a dense, upright clump. New leaves rise from short stems and build a rounded crown with visible colour across the upper leaves.

The leaves are smooth, oval to lance-shaped and slightly glossy, with red to salmon-pink colouring near the midrib and green tissue around the blade edge. As new growth expands, the colour sits close to the centre of the leaf, giving the crown a warm core with a cooler green outline.

Aglaonema 'Spring Red' colour profile

  • Compact, clumping Chinese evergreen with short upright stems
  • Red-pink central colour with green margins and soft irregular markings
  • Smooth, broad leaves held in a dense rounded crown
  • Slow to moderate indoor growth with new leaves forming from the centre
  • Keep warm, evenly moist and away from direct midday sun

Aglaonema 'Spring Red' crown development

Aglaonema 'Spring Red' is a cultivated Aglaonema selection grown for patterned foliage, compact crown growth and warm red-pink colour. It carries the familiar Chinese evergreen habit, with short stems, broad leaves and steady clumping growth in a pot.

In a container, the plant gradually forms a short-stemmed clump. Older leaves sit lower around the base while new leaves emerge from the crown, creating a layered look as it matures.

Aglaonema 'Spring Red' care essentials

  • Light: Place in bright filtered light or gentle morning sun. Direct midday sun can mark the coloured leaf tissue.
  • Watering: Water when the top 3–5 cm of substrate feels dry. The pot needs to feel lighter before watering again.
  • Substrate: Use a loose mix with coco coir, fine bark, perlite or pumice so the roots stay lightly moist with air around them.
  • Drainage: Keep the plant in a pot with drainage holes and empty any standing water after watering.
  • Temperature: Keep at 18–27 °C. Cold windowsills and draughts can cause dull, water-soaked patches on the leaves.
  • Humidity: Normal indoor humidity is usually suitable. In very dry heated rooms, grouping plants or using a humidifier reduces crisping on new leaves.
  • Feeding: Feed lightly every 4–6 weeks in spring and summer with diluted foliage-plant fertiliser.
  • Repotting: Repot when roots fill the pot or the substrate breaks down, usually every 1–2 years.
  • Grooming: Remove fully yellow lower leaves at the base so the crown stays open and dry.
  • Propagation: Divide rooted basal shoots or root stem sections with at least one node in warm conditions.

Aglaonema 'Spring Red' leaf responses

  • Soft yellow lower leaves: Check for a wet lower root ball, blocked drainage or a cover pot holding water.
  • Brown dry tips: Check watering gaps, dry heated air and mineral build-up from strong fertiliser or hard water.
  • Pale scorched patches: Move the plant away from direct sun through glass and leave damaged leaves until replacements grow.
  • Drooping with damp substrate: Inspect the roots and allow the mix to dry further before the next watering.

Aglaonema 'Spring Red' safety

Aglaonema 'Spring Red' contains insoluble calcium oxalate crystals. The plant can irritate the mouth, throat and digestive tract if eaten, so keep it away from pets and small children. Wash hands after pruning if sap touches the skin.

Shipping Notes
  • Free Standard Shipping on $100+ Orders to the USA.
  • Except Preorder products are shipped in 48 hours.
  • Delivery to the USA:
  1. Standard Shipping : 3-10 business days
  • If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
  • We offer a 30-day return/exchange service after receiving.
  • Final sale items are not eligible for returns or exchanges.
  • To process your return/exchange, please contact us at [email protected]
  • Please click here for more details>>> Return & Exchange Policy
SKU: 84411136256

Discover Niche Categories That Outsell mature aglaonema

Top-Converting Item to Boost Your Average Order

4.6 ★★★★★
Based on 482 reviews
Sort
Highest Rating
Newest First
Oldest First
Product Reviews
J
Verified Purchase
JBDoge
Whiting, US
★★★★★ 5
Wish they came with instructions...
They are cheap and work great. They plug right into my Pioneer vsx521 receiver and my Paradigm Atom monitor speakers. I wish they came with instructions, because it took me about 10 minutes to realize the bottom part unscrews in addition to the top part. Here are my instructions for installation: 1) Unscrew the bottom part of this connector (the thin metal underneath the red/black ring). 2) Make sure the Banana Plug (which may be loosely screwed into the top part of the connector) is fully tightened down 3) Strip your wire tips to 3/8 of an inch (or just slightly under) 4) Run the first newly stripped wire end through the bottom part you removed in step 1, such that the stripped end of the wire is entering through the flat end and exiting through the smaller threaded end. 5) Leave about 1/8 to 3/16 of an inch of stripped wire hanging past the exit hole. 6) As evenly spaced as possible, bend the over-hanging wire strands over the exit hole (all around it, like a hat). If done properly, the wire should not fall out if you give it a VERY GENTLE tug. 7) Screw the top metal part (with the actual banana plug) back onto the bottom part. It may be difficult if your stripped wire is hanging too low. I've used a pair of pliers to grip the bottom part of the connector while I twist the banana plug side with my hand. If done correctly, you should be able to put a lot of tension between the wire and connector without removing/damaging it. UPDATE: I just recently helped my dad install his 5.1 system without these... it sucked... This item (5 pairs of them in this case) and a good wire stripper can save you alot of pain (both physical and mental). The connectors on the back of his receiver are the kind where bare wire comes in from the side and then the connectors screw down (with a banana plug hole in the center which is where this product would come into play). I felt like a surgeon trying to get a bare wire end into the little slot, and then holding it there while I tighten the connector which is almost impossible since they are so close together... GET THESE!
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on February 8, 2012
R
Verified Purchase
R. Jackson
Boise, US
★★★★★ 1
'Monoprice' = Worst stereo banana plugs on T-H-E market.
Size: 5 Pack, Pattern Name: Banana Plugs
The absolute WORST in stereo banana plugs - HANDS DOWN. After installing stereos and components for over 30 years, I'd say I'm experienced. These banana plugs fail at EVERY part of the design. Allow me to explain... 1) Starting with the tips, they are loose off the bat and fit LOOSELY in either the stereo input studs or speaker input studs by their 'girth'. They do not firmly seat in any plug and for this setup, I'm using a nearly $2K setup all together. They 'rock' back and forth (when inserted) and thus create a non-permanent connection, again, seriously making these utter junk. I've seen some items you can get by with over the years, but these aren't even rock bottom. They are unusable! 2) Next, the banana plugs themselves comes as three pieces. No non loosening o-ring seal but a plastic colored want-to-be imitation for positive and negative notation. Why do these stupid things come in three pieces? - I simply can't tell you why. I do know they serve no specific piece to solving the puzzle of installation so why do they come in three pieces...? My speculation is they are cheap china knockoffs. 3) The 'way' in which you normally install the trimmed wiring internally with the 'two-piece' design permits you to firmly CRIMP and hold the unsheathed wiring; but these do not. The overlap/overlay of the exposed wiring can only be about 2/16's of an inch thus not much to create a proper connection with. This single fact eliminates these plugs as even worthwhile component add ons; period. If you can't achieve a good ground/wiring connection, these are a defeated purpose... 4) Because of the design of these, they have no room to crimp and screw on the cable so your forced to nearly break your fingers in an attempt to get the unsheathed wire to overlay the internal threading and twist them on with all your might. This in effect breaks nearly every wire thread internally and then they breaks off inside. Absolute garbage. These are total pieces of non-quality junk that did nothing but makes me waste 30 minutes on attempting to get them securely on and another 25 to locate my Amazon account, find this product in my order and ALARM anyone else from making the same mistake I made. Now, I find out I can't even get a return on these. Thanks Amazon. Thank you third party retailer. You just made me a very dissatisfied decade long customer.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on August 17, 2016
A
Verified Purchase
Amazon Customer
Omaha, US
★★★★★ 5
Nice quality
Had to return due to our mistake but the mechanic said it was good quality. Ordered the correct size and worked great.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 30, 2025
K
Verified Purchase
katelyn traut
Fort Morgan, US
★★★★★ 5
Perfect fit
Worked great for a 1965 mercury thunderbolt 150hp
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on June 3, 2025
L
Verified Purchase
Lawrence Brown
Phoenix, US
★★★★★ 5
MerCruiser Replacement Parts
OEM quality MerCruiser Alpha 1 Gen1 replacement part. Everything you need and some things you don't because it's a universal kit that works for several models.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on July 19, 2025

recommand products